======================================================================== HTML::Defaultify 1.0.1 (released June 17, 2002) Copyright 1996, 1997, 2002, James Marshall (james@jmarshall.com) For the latest, see http://www.jmarshall.com/tools/defaultify/ ======================================================================== This Perl module is used to populate HTML forms with default values. Unlike other tools that fill a similar niche, this module can handle any existing HTML page; this approach allows a clean separation of HTML development from Perl program development. For more complete documentation, run "perldoc HTML::Defaultify", or to run perldoc on the Defaultify.pm file before installing it, run "perldoc -F Defaultify.pm". If your perldoc fails and says it "cannot find blib", then run perldoc from a directory with no Makefile.PL-- it's an apparent bug in some perldoc's. COPYRIGHT This software is copyright (c) 1996, 1997, 2002, James Marshall. All rights reserved. This program is free software; you can redistribute it and/or modify it under the same terms as Perl itself. REQUIRES HTML::Defaultify prefers to use HTML::Entities. If HTML::Entities is not available, HTML::Defaultify works without it but slightly less reliably when character entity references are used. Install HTML::Entities if you can. INSTALLATION Like most Perl modules, HTML::Defaultify is installed by unpacking the distribution and running these commands: perl Makefile.PL make make test (optional) make install (normally must be done as root) That should be sufficient. For documentation on usage, run "perldoc HTML::Defaultify". ======================================================================== http://www.jmarshall.com/tools/defaultify/